Great Miami River Flood Damage
Floodwater from the Great Miami is pumped out, its silt is cleared and the structure is dried before any rebuilding starts.
A basement after a storm, a sump that could not keep up, a frozen line in January or a roof opened by wind. Call (833) 490-5225 at any hour.
Fastest: call (833) 490-5225. Or send this and we call you back.
Local weather drives activity here: heat, humidity and rain change what shows up week to week.
Kettering Water Damage Restoration answers water damage calls for Kettering, Montgomery County and the Dayton metro, 24/7. Standing water is removed first, then the wet structure is dried to measured readings, and dated photos and logs are kept for your records.
Calls around the Miami Valley tend to start in a few places: a basement that filled after heavy rain, a sewer line that backed up through a floor drain, a river that rose past its levee or a storm that opened a roof. Each starting point leaves a different pattern of wet material, and each needs a different first step.
While you wait for help, turn off the main if water is coming from a pipe, keep power off in wet rooms, stay out of standing water and photograph the damage from the dry side of the room. Those details are the first thing the crew asks about, and they make the walkthrough shorter and clearer.
Pick a service for symptoms, process and typical cost, or call and describe what you hear and see.
Floodwater from the Great Miami is pumped out, its silt is cleared and the structure is dried before any rebuilding starts.
When floodgates close and the river stays high, water can still come into a house from drains and low ground, and it needs the same careful pumping.
Dayton sits where the Mad, Stillwater and Great Miami rivers meet, so water from any one of them can reach the same low ground and the same basements.
Standing water is pumped and vacuumed out of the lowest rooms first, before silt is cleared and drying begins.
Rain that enters through walls, floor cracks, drains and window wells is pumped out, the wet materials are removed and the basement is dried.
Sewage that backs into a house is contaminated water, and it is removed, sanitized and dried as a separate job from ordinary flood cleanup.
When a sump stops during a storm, the pit overflows into the basement, and the water is pumped out, the wet materials are removed and the floor is dried.
Wind that opens a roof lets rain into the attic, the ceilings and the walls, so the water is removed and the structure is dried around the opening.
A roof leak that soaks the attic, the insulation and the ceilings below is traced, the wet materials are removed and the structure is dried to readings.
Water that has collected above a ceiling is drained, the sagging drywall and wet insulation are removed, and the cavity is dried before the ceiling is closed.
Air movers and dehumidifiers run inside the walls and under the floors until moisture readings show the framing has reached its dry targets.
Mold follows water that stays in a house, so the wet materials are removed, the surfaces are cleaned and the structure is dried to readings before the rebuild.
A split line in a cold room floods the space in minutes, so the water is shut off, the wet materials come out and the structure is dried to readings.
A leaking tank or fitting floods the utility room or basement, so the water is shut off, pumped out and the wet materials are removed and dried.
A failed hose, drain or connection lets water out of a washer, dishwasher or refrigerator, and the floor and wall beneath it are dried after the water is shut off.
Water that collects under a house on its joists and insulation is pumped out, the soaked insulation is removed and the framing is dried before the floor is checked.
A leak inside a wall, under a floor or beneath a slab is traced by readings, the wet materials are opened and removed, and the structure is dried.
Water in a business space is pumped out quickly, the wet materials are removed and the structure is dried so the space can reopen as soon as the readings allow.
Phones are answered 24/7, so a call at three in the morning about water spreading across a floor reaches a person who can walk you through the first steps.
Standing water is pumped or vacuumed out first. Air movers and dehumidifiers work on moisture held in materials, not on a flooded floor.
Equipment stays until moisture readings for wood, drywall and subfloor reach their targets, not for a fixed number of days.
Water from a river, a flooded street or a backed-up drain gets its own steps, and porous materials it touched are removed rather than dried in place.
Dated photos, moisture logs and removal lists are kept as the work goes, so the paperwork exists before anyone asks for it.
The first call covers the source, the rooms and whether the water is still moving. A figure for the whole job waits for a walkthrough.
If a pipe or an appliance is the source, shut off the main and stay clear of wet outlets. The first questions are where the water is coming from, whether it is still coming and which rooms are wet.
A crew walks the property, marks the high-water line and takes moisture readings on each material. The scope is written from those numbers.
Standing water comes out first. Carpet, pad, insulation and other materials that cannot be dried in place are removed with the reason recorded.
Drying equipment runs until the readings reach target. Dated photos, logs and the removal list are handed over so the record is complete.
Shut off the main water valve if the source is a pipe, turn off power to wet rooms if you can reach the panel without standing in water, move valuables up and out of the water, and photograph the damage before anything is moved.
Water moves along the lowest path it can find, which in a Kettering basement is often the floor drain, the sump pit, the joint where the wall meets the slab or the bottom of the stairs. Watching where it runs tells the crew which materials are wet and where the readings should start.
Do not step into water over an electrical outlet or cord. If you cannot reach the panel from a dry spot, call the utility and wait for the power to be shut off at the meter. A crew can take it from there once the area is safe.
River water, sewer backup and clean supply water each need different handling. The first two are treated as contaminated, so the porous materials they touch usually come out. Clean supply water is often dried in place.
A burst supply line in a finished room may leave the carpet pad wet but the subfloor sound. Sewer backup and river water change that picture, because the materials they soak are usually removed rather than dried, and the crew handles the removals with more care.
The source is also the first thing the insurer asks about. Telling the call-taker where the water came from, even roughly, gives the crew a faster start and gives the record a clear beginning.
Drying ends when measured materials reach their target readings. It does not end on a set day, because a wall that holds water inside a cavity takes longer than the surface suggests.
The crew logs readings for drywall, wood trim, the subfloor and the framing, and each visit compares the new numbers with the last. Equipment stays where the readings are still falling, and comes out when they reach target.
Ask to see the log. A trend that moves steadily toward target is what a good drying job looks like, and a log that stops moving tells you the next step should be a closer look at the wall or floor, not another day of fans.
The call covers the safety steps and the first questions. The walkthrough measures the wet area, the depth of the water and the materials involved, and only then is a scope written.
Kettering Water Damage Restoration takes the first call, and someone picks up and takes the details of the loss. The safety steps come before anything else. A crew is then sent to the property as one is available, and it writes the scope from what it measures on site.
No honest figure exists for a whole job before the walkthrough, because the wet materials cannot be counted from the doorway. What the walkthrough gives you is a written scope with each line explained, which you can compare with any other scope you receive.
ZIP 45429, 45419, 45440, 45420
ZIP 45419
ZIP 45439
ZIP 45449
ZIP 45459, 45458
ZIP 45402, 45403, 45404, 45405, 45406, 45409…
ZIP 45305
ZIP 45430, 45431, 45432, 45434
ZIP 45404, 45431
ZIP 45342, 45343
ZIP 45301
ZIP 45066
ZIP 45370
ZIP 45424
ZIP 45426
ZIP 45324
ZIP 45327
ZIP 45068
ZIP 45385
ZIP 45345
ZIP 45005
ZIP 45325
ZIP 45377
ZIP 45315
Kettering, OH · 25 km service radiusCall (833) 490-5225
We also cover many smaller communities across Montgomery County. Check your ZIP.
If it's an emergency, call now. For non-urgent water damage restoration, send the form and we'll call you back.
A restoration scope in Kettering follows the area that stayed wet, how deep the water rose, how long materials held it, what kind of water it was and which materials cannot be dried in place.
The March 1913 flood put downtown Dayton under as much as twenty feet of water and killed hundreds.
When the Great Miami is high, the valley's dams and floodgates may be working, parks and roads may close, and the house has to be checked from the outside before water reaches the basement.
Phones are answered 24/7, holidays included. A crew is sent as one is available, and no arrival time is promised, because a phone line cannot guarantee one.
No honest one for the whole job. The first call sets the emergency steps. The total follows the walkthrough and the readings, and it should be written before work begins.
The areas we serve are listed on the area pages, along with the ZIP check. Call with the street and ZIP, and coverage is confirmed for that address.
Do not wait to stop the water or move valuables. Photograph first, then ask the insurer what it requires before removals begin. Drying itself often starts while the claim is being reviewed.
Mold that follows water damage is covered on its own page. Drying the structure quickly is the best way to limit it, and the readings show whether the materials are reaching a dry state.
Tell the call-taker. The source affects the first steps and the paperwork, and the crew writes the scope from what it finds inside the house.